Showing 37 questions in: perform
Answers
Category
Brands
Want to know something? Ask a question
Shin Ip
By Shin Ip
July 14th, 2010
Answered in 6 minutes
Manage My Life
Hello, If you take a look in your Manual you'll see that there is a page of Maintenance, it will give you instructions on how to maintain your refrigerator. If you don't have your manual that's not a problem, you can easily go to Manage My Life and click on the Manuals button, then you must put in your model number and then the manual will appear. I attached the link below. Hope this helps!!!!
By Manage My Life
July 14th, 2010
Manage My Life
November 21st, 2009
Mark Thomas
I have provided you the calibration instruction below that you should find helpful.
By Mark Thomas
November 23rd, 2009
Manage My Life
February 8th, 2009
scott d
There is no other problem associated with the gear breaking on the ice maker. Replacing the module is a simple repair. Remove the three screws holding it in place and it will just lift off. When you put the new one back just line up the ejector arm to match the cam on the module and push it down in place. Tighten the screws and it's ready to go. If you need more assistance you can resubmit your question with more details.
By scott d
February 11th, 2009
Manage My Life
January 30th, 2012
Answered in 8 minutes
Joseph Perez
Error codes can be a hassle and keep your appliance from working properly. I suggest you add to the thread of this question and include the full model number of your washer so that the expert can provide you with a more detailed answer. I am adding a link below to help you with your question while you wait for your expert response.
By Joseph Perez
January 30th, 2012
Manage My Life
June 12th, 2012
Answered in 10 minutes
afritz afritz
I understand how confusing it can be to get the error code F5 displayed on your range. While you are waiting for an expert to respond, I have attached a helpful link below that may provide information to assist you with your question. Have a great day!
By afritz afritz
June 12th, 2012
Christi Colba
December 16th, 2009
Answered in 0 seconds
Manage My Life
Most small turbines are simple mechanical devices with very few moving parts, and they do not require regular maintenance. They are expected to last up to 20 years and during that time to operate completely automatically.
By Manage My Life
December 16th, 2009
Manage My Life
September 27th, 2009
Manage My Life
In reference to your Frigidaire, model number ATF7000FG0:

All washer must drain out of the tub before the spin cycle will start.

Possible Causes

:

Washers require an unrestricted drain hose to properly pump out the water.

Press the Cancel or pause/Cancel button to clear the display.

For a kinked drain hose

:

Check behind the washer for a kinked drain hose. If hose looks kinked, it will need to be carefully pulled from the drain stand pipe and straightened or rerouted to prevent it from Kinking again.Note: If the drain hose is damaged, it must be replaced.

Make sure the washer is not pushed back too far crushing or kinking the hose. If needed pull the washer out away from the wall.

_For a clogged household drain- Contact a plimber to clear the clogged drain.
By Manage My Life
September 29th, 2009
Manage My Life
December 9th, 2009
Answered in 18 hours
Manage My Life
The recommended maintenance on the treadmill is to remove the motor hood and vacuum dust and debris from the control board and motor areas.

The bearings in the front and rear rollers and the motor are sealed. The walking belt requires lubrication after around 200 hours. I am sending you some information on testing and lubricating the walking belt.

If the treadmill is stored in a cold area, that might cause it to be sluggish.

To test the walking belt lubrication, do not turn the treadmill motor on. Set the elevation to the highest level. Stand near the front of the walking belt. Push yourself firmly toward the rear of the treadmill. If the belt is properly lubricated the belt will take you to the rear edge of the treadmill and dump you off on the floor. If you move and stop, the belt needs lubricating.

The part number for the belt lubrication kit is 219168. You can buy it at [searspartsdirect.com]. The cost is around $4.00. The application instructions should be in the package, but in case they are not here is how to apply the lubrication.

Turn the walking belt until the belt seam is along the top of the front roller. Raise the belt on one side in the center of the walking board front to back as high as you can. Apply ½ the tube of lubrication to the walking board in a zig zag fashion moving from front to back. Move the belt until the seam comes up on top of the rear roller and lift the belt again and put the rest of the lubrication on the walking board in the same manner. Turn the treadmill on and walk on the belt for 10-20 minutes. Walk all over the belt to distribute the lubrication evenly on the walking belt and board.
By Manage My Life
December 10th, 2009
THERESE KOKOT
December 16th, 2009
Answered in 0 seconds
Manage My Life
Yes. To access menus without the mouse, hit the alt key, and then the underlined letter in the menu title. For example, to open the File menu, hit alt F. To navigate both between and within menus, press the underlined letter or use the arrow keys and press Enter to select the option you want. To get out of your menus and into your main document, press escape twice. The right-click button on your keyboard -- the button with a graphic of a rectangle with horizontal lines and a pointer -- will, if pressed, offer you the relevant menu of choices for the area in which you're working. In addition, there are a number of shortcut keys that allow you to use the keyboard to execute commands.To familiarize yourself with these, look in each menu list. They are listed beside the command relevant to them. Many of these are standard shortcuts, interchangable between Microsoft programs. For example, control X (holding down the control key and pressing x) cuts copy. You can also design shortcut keys for yourself. To create your own shortcuts in Word (XP and above), click on the Tools menu, then Customize. On this dialog box, find the button marked keyboard. This will open up a list of all the various aspects of Word that can be customized, along with the commands that match the category. Once you match your category to a desired command, any current shortcut for that sequence will appear below. Beside it will be a box for the new shortcut key. The shortcut key will usually need to include one of the modifier keys (control, alt, shift) and another one or two keys. Press the combination you want to assign it to the task you've chosen. If that combination is already linked to another shortcut, the shortcut will appear below. Choose another one or replace the shortcut with your desired one. Hit Assign and then close this dialog box and the one nested below it to set your shortcut.
By Manage My Life
December 16th, 2009
Manage My Life
December 16th, 2009
Answered in 0 seconds
Manage My Life
Study after study shows that over the long haul, it is very difficult to beat the steady performance of index mutual funds. While during given time periods certain actively managed funds may perform better that an index fund, in the long run index funds do better.
By Manage My Life
December 16th, 2009