?
Manage My Life

What does error code "F35" mean on my Kenmore HE3t steam washer?

It is also followed by error code SUDS?

Tags
Kenmore , Washers
Sign in to answer a question
3 Answers from these members:
Lyle W
Hello Bud. I just ran across this post. I am not sure what you are talking about. Reply with some details if you need assistance. Thanks.
by Lyle W Earned 2,989 community points in Kenmore
October 29th, 2012
Comment
0 votes
Manage My Life
sell the junk to junk yard whirlpool or any one ele should be ashamed to sell it
by Manage My Life
September 17th, 2012
Comment
0 votes
Lyle W
The F35 indicates a water level pressure sensor failure. The SUD is normally displayed when there is excessive detergent suds in the tub. A loose wire harness connection could be causing this problem if there is no water or suds in the tub. I recommend

unplugging the washer

and removing the top panel. Screws at the very back of the top panel secure it to the washer frame. Remove the screws and then pull the top panel slightly back and then up and off of the washer. The analog water level pressure sensor is shown in the first image below. The second image shows a clear picture of this component. Check the wire harness connection on this sensor. If you find a loose connection, secure the wire harness properly on the component then reassemble and test the washer. If you continue to get the F35 code, then this component will need to be replaced.

You can order a new analog water level pressure sensor from the

Sears PartsDirect

website.

If you need more help with this problem, resubmit your question with additional details and the full model number of your Kenmore Elite HE5t Steam washer.
by Lyle W Earned 2,989 community points in Kenmore
May 22nd, 2009
Answered in 21 minutes
Comment
0 votes
Didn't find what you are looking for? Ask a question