?
Manage My Life

replacement belt for kenmore 80 series top load washers

Need to replace a belt to our Kenmore 80 series top load washer model number 110.27892791

Tags
Kenmore , Washers
Sign in to answer a question
2 Answers from these members:
Manage My Life
I have a Kenmore Series 80 washer that wont spin.
took care of the lid switch.
the coupler is fine & spinning
the clutch is spinning

what should I check next?

thx Dave
by Manage My Life
July 31st, 2012
Comment
0 votes
Manage My Life
This is a direct drive washer and does not have a belt. This model uses a drive coupler. Please see the instructions provided below on how to replace the drive coupler for your Kenmore washer. NOTE; on this model pull to unsnap the console end caps #’s 8 & 15 to access the screws you will need to remove.

Drive coupler; 285753A

searspartsdirect.com



If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website:

Sears Home Services

.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.
by Manage My Life
May 20th, 2010
Answered in 3 hours
Comment
0 votes
Didn't find what you are looking for? Ask a question