?
Manage My Life

i have a kenmore dryer n i need to know how to put it back together.gas dryer11072602101 if you could show me how to assemble it back step by step.

i opened my dryer because it had flood in our basement, and it does get hot, i just can't get the tumbler to stay on track, please help, it is a kenmore gas dryer 110.726022101. i opened it to clean it out n get back to working. working it does do, gets hot, the turnning drum will not stay in place it's rubbing the back inside the dryer.

Tags
Dryers , Kenmore , Washers
Sign in to answer a question
4 Answers from these members:
Manage My Life
Thank you for the feedback on the dryer. please submit your freezer question from the home page of MML to avoid confusion & to get a quicker response.
by Manage My Life
September 14th, 2010
Comment
0 votes
Manage My Life
thank you both Jacquelines. for info. and biker dave thanks alot, i had the felt folded up n you know i went to sears parts repair center, and they would not even tell the problem. thank you bot so much. now i have try to get my upright freezer getting cold again, please help. kenmore 25326432100, it was also in the 2ft. flood water. it's on , but won't freeze.
by Manage My Life
September 14th, 2010
Comment
0 votes
Manage My Life
First,

disconnect power

to the dryer. Once you remove the drum you will have complete access to check the drum rollers, belt & idler. Please follow the disassembly instructions in the image in the link attached below so the reassembly will match the instructions. The drum rollers #21 ride in the groove of the drum for the rear drum support & the front of the drum rest on the front door trim on the felt pad called a seal & bearing, image #44. The trick is centering the drum on the rollers & then put the belt in place while holding the front of the drum up. After installing the belt on the motor & idler pulley manually rotate the drum counterclockwise (watch for razor sharp metal edges) a couple of times until the belt is in alignment. Now, while holding the drum front up with one hand position the front panel on the lower hanging clips #13 with the other hand. Hold the drum up & push the front panel lip with the felt pad under the lip of the drum front. Hold the front panel tight against the drum while securing the 2 screws holding the front to the sides. After securing rotate the drum manually counterclockwise a couple times to check for anything binding up. Be sure the rear drum felt is not folded. I have provided you with step by step instructions with pictures from the service manual in the link attached below. Remember to

disconnect power to the dryer

before attempting access. NOTE: I recommend replacing the slide idler #36 with the roller idler; 691366 $15.77

searspartsdirect.com



what do i have to remove to replace the drum belt on a sears dryer model number 11062702101?
by Manage My Life
September 10th, 2010
Answered in 23 hours
Comment
0 votes
Manage My Life
Understanding how a dryer is put together can be very difficult. While your waiting on an expert response you can visit the ParsDirect website enter your model number to view the diagram of your dryer. I have provided the link below. I hope this helps!
by Manage My Life
September 9th, 2010
Answered in 16 minutes
Comment
0 votes
Didn't find what you are looking for? Ask a question