JAMES BRALLEY

My Kenmore dishwasher, model 665.17039402, stops 20 minutes into cycle. The clean led blinks 7 times. What can be the problem?

by JAMES BRALLEY Last activity date:
November 17th, 2009

My Kenmore dishwasher, model 665.17039402, stops 20 minutes into cycle. The clean led blinks 7 times. What can be the problem? Incoming water temp over 100 degrees. Ran Diagnostics cycle, but not perceive defect.Info on Diagnostics cycle does not reveal what item is defective.

Tags:
Dishwashers , Kenmore , Building Supplies
Be the first to comment
Ask your friends
Answers (2)
Manage My Life
In reference to your Kenmore dishwasher, model 665.17039402

Problem

: Stopped running, will not start and clean led blinks 7 times, then repeats

Control is programmed to stop the current cycle and not allow any further cycles if it suspects a faulty heater (no temperature increase detected in heated intervals). Control blinks the

Clean LED 7 times

In repetitive fashion and disables the

Start/Resume

key until cleared.

Running Diagnostics clears the control and allows it to operate again. If heating problem's not corrected though, the control will stop running again on next cycle. See below

Heater circuit problem

:

Open in heater

Open connection or component in heater circuit

Faulty heater drive circuit on control

Check

:

Unplug dishwasher

Check all components and connections in the water heating circuit or heat dry circuit

Check resistance of heater

Check resistances of all connections and components between the control and heater

Check operation of heater and temperature sensor in diagnostic cycle
by Manage My Life
November 17th, 2009
| Be the first to comment
0 votes
answers
To view more answers
Join Now
IT IS FREE
Add your own answer
Sign in to answer a question
Didn't find what you are looking for? Ask a question