Skip to content
Manage My Life

What is error code E68 on a Frigidaire dryer AEQ6700FS?

Was starting the dryer and it ran fine for a few seconds and then stopped and started beeping at me and flashing E68. If I clear it and start the dryer it will do the same. Checked the lint trap and the exhaust and both were clear.

Dryers , Frigidaire , Washers
Sign in to answer a question
1 Answer from this member:
Mark Thomas
The error code E68 is a stuck button error code. I recommend checking each button to make sure it loose in the plastic console. The button should rock side to side a little bit. If all the buttons are loose you can try to reset the unit control by unplugging the dryer for two minutes. If the error code comes back you will need to replace the unit control. The part number is 134557201 and can be ordered from this link.

Sears Parts Direct

I have e-mail the replacement instructions to your address on file.
by Mark Thomas Earned 3,355 community points in Washers
December 23rd, 2009
0 votes
Didn't find what you are looking for? Ask a question
Get up to
% off
On Dryers