Departments
Brands
Top Brands
Brands You Follow
Stores
Nearby
You Visited
You Follow
You Search For
Topics
Hottests Topics
Catalogs
Featured Catalogs
People
Trendsetters
People Like You
Apps
Your apps
Discover apps
Get Advice
Top Questions
Your Q&A
Friends Asked
Ask A Question | Show All Questions
More on ShopYourWay
Manage My Life

water wont shut off on washing machine Kenmore model # 110.29812890

by Manage My Life Last activity date:
July 20th, 2010

kenmore washer model # 10.29812890 water wont shut off

Tags:
Kenmore , Washers
Be the first to comment
Ask your friends
Answers (2)
Joey S
If the water will NOT shut off by pushing the timer knob in or by unplugging the washer the water inlet valve has stuck open and it will need to be replaced.

If the water WILL shut off by pushing the timer in or by unplugging the washer then the likely failure is the water level pressure switch or the water level pressure switch hose has an air leak/hole in it somewhere. If the pressure switch air hose has no holes in it, replace the water level pressure switch.



In order to access and check to see if the water level pressure switch hose has pulled off the water level pressure switch and to check the pressure switch hose for leaks will require placing the control panel in the service position and removing the washer cabinet.

First, disconnect the power cord from the power source

.

The console (key#26) will need to be placed in the service position by removing two (2) hidden screws, one (1) screw is located at the bottom of the left hand end cap (key#7) and one (1) screw is located at the bottom of the right hand end cap (key#10).

In order to access these two (2) hidden screws, the left hand end cap trim (key#8) and under the right hand end cap trim (key#11) will need to be removed.

To remove the trim (key#8&11), place you finger behind the trim at the very top and bend it up enough to clear the console and then hinge it towards the front and off. See second image below.

Remove the hidden screw under each end cap trim. Slide the console forwards about 1/4 inch and the raise it upwards and hinge it over the rear panel.

Disconnect the 3 wire lid switch harness plug located on the top. Pop the two (2) gold colored cabinet retainer clips off. See third image below.

Place the tip of a flat tipped screw driver down into the first valley and then push the handle end to the rear of the washer to pop off the cabinet clips.

Open the lid and grab the opening and tilt the top of the washer cabinet forwards just a few degrees and then walk it backwards and off.

You now have full access to the water level pressure switch hose.

Reverse the procedure to re-assemble the washer cabinet.
by Joey S
July 20th, 2010
| Be the first to comment
0 votes
Manage My Life
Hello, I can't imagine the washer filling up without stopping. I see that someone else on Manage My Life has asked a similar question to yours. I have provided the link below. hope this helps!
Answered in 15 minutes
by Manage My Life
July 17th, 2010
| Be the first to comment
0 votes
Add your own answer
Sign in to answer a question
Didn't find what you are looking for? Ask a question