Skip to content
Manage My Life

Freezer ice maker doesnt work. Red light in freezer in sensor flashing twice. So far replaced sensors and ice maker. Stii no ice. Inlet Valve. Model 10651554104

KENMORE MODEL 10651554104 Ice Maker problem

Kenmore , Refrigerators , Appliances
Sign in to answer a question
2 Answers from these members:
Manage My Life
I can see having red flashing lights on Freezer ice maker can be very hard to figure out what it really mean. While you are waiting on an answer from an expert. A suggestion I have while you are waiting. I found this really great link on why you might be getting red lights on Freezer. I attached the link below. Hope this helps! Good luck.
by Manage My Life
October 4th, 2010
Answered in 10 minutes
0 votes
scott d
Teh information you have already received is correct. Two flashes will indicate the boards are ok. The icemaker in this model can stop working for a few reasons. Some are listed below:

The icemaker itself can fail

The water valve may not open

The optic boards can fail

The fill tube can freeze up

Freezer temperature not cold enough

The blinking led light can be flashing a code that will indicate the problem. If it flashes 2 times pauses and continues this while the door is open, it’s normal. Now disconnect power to the refrigerator. To check this icemaker, slide it out, so the front cover can be removed, to access some test terminals. There is a clip located on the back right corner of the icemaker that will need to be removed, to slide the icemaker out. There will be a screw at the bottom of the clip holding it. I’m sending a picture with instructions to remove this clip. With the clip removed, slide the icemaker out and remove the front cover. You will now see the test terminals, which are marked (see picture). Now remove the 3 screws holding the receiver board on the right side and disconnect the harness from the board. Place a jumper between the black and black/white wires (see picture). Now use a second jumper and place it between the L – V terminals on the module. Reconnect the power and with both jumpers in place, water should now flow to the icemaker (be prepared to catch water from the fill tube). If water does flow, the icemaker # 2198678 will need to be replaced. If no water flows but you can hear a humming noise, the water valve # 4389177 will need to be replaced. If nothing at all happens, some voltage checks will need to be made.

If you do not feel confident repairing this problem or doing any voltage checks yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website:

Sears Home Services

. If you need more assistance additional details will be needed.

Safety Notice

: Be sure to disconnect the appliance before performing any troubleshooting procedures. If you are not comfortable with doing any voltage checks or repairs that might be recommended, please contact a local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.
by scott d Earned 139,392 community points in Appliances
October 5th, 2010
Answered in 24 hours
0 votes
Didn't find what you are looking for? Ask a question
Get up to
% off
On Refrigerators