I do not have a picture of this set up available currently. If you put the belt on the mower deck and hook the spring to the pulley you should be able to pull the spring straight back (toward the back of the mower deck) and see the bracket it connects to. The place where it connects will show some wear to it but you may have to look closely. Basically it doesn’t matter where it hooks just so long as it holds tension on the deck belt. I don't think this one has but one place where the spring will connect when pulled back. You will most likely not be able to hook the spring in place with the belt on so you will need to take the belt off once you see the spot and then connect the spring. Put the belt back on after the spring is in place.