Your question was published, help is on its way!
Changed batteries in my garage door opener, now it wont work even after reprogramming it.
Garage Door opener: 139.53681
3 button remote
After replacing the battery in my remote, I can't get it to work anymore. I even canceled all the codes for all 3 remotes and reprogrammed them all to make sure I was doing it correctly. The other 2 reprogrammed and work great.
When I first started I was looking at the remote and noticed a hole in the back of the remote. I looked in it and it looked like a screw. I thought that screw held the remote together so I started unscrewing it. When I realized that screw had nothing to do with opening the case I stopped. I then used a screwdriver to open the case and then changes the battery. I reprogrammed all the remotes and the one that I changed the battery on still wont work.
What is the screw on the circuit board for? Does this change the frequency of the transmitter by any chance? I'm wondering that's why my remote will not work now. Any ideals on how to fix??
to answer a question
3 Answers from these members:
The Managemylife web site is a good resource to find out what may be happening with your Garage Door Opener. I did some research for you at Managemylife.com and found an excellent article that also has multiple expert answers at the bottom of the web page that addresses the most common questions that have been asked by other members. I hope this will help until your expert can answer your specific question. I attached the link below.
Didn't find what you are looking for?