?
Manage My Life

error codes and self test on whirlpool dishwasher

my dishwasher is not running a full cycle it will start running the water then sometimes just shutoff or it will go into another mode like drying within second of starting is there a self test mode i can run or does it just sound like the control board and order a new one dishwasher i a whirlpool quiet partner 2 model # du1055xtvb1

Tags
Dishwashers , Whirlpool , Appliances
Sign in to answer a question
8 Answers from these members:
Fred M
Great. That is the type of problem you don't want to spend money on a service call. Great job.
by Fred M Earned 3,503 community points in Appliances
February 4th, 2013
Comment
0 votes
Manage My Life
I took plate off and removed the wire nuts and checked with meter and didn't have any power. I then checked an outlet to make sure meter was good. I traced the power cord thinking that is was hard wired into a recepticle, and found that is was plugged into recepticle under sink. When looking at it closer, I discovered that the spray handle hose had worked the plug loose over time. I pushed plug in and my dish washer is now working.
by Manage My Life
February 4th, 2013
Comment
0 votes
Fred M
If there are no lights and the thermal fuse is okay then I suggest you check the wire nuts connecting the house wiring to the dishwasher. Remove the kick plate to access the dishwasher junction bos. A loose wire nut or connection may be the problem. If you reply with a model number I may be able to bring up a wiring diagram for your particular dishwasher.
by Fred M Earned 3,503 community points in Appliances
February 2nd, 2013
Comment
0 votes
Manage My Life
My quiet partner 2 is dead. no lights, no buttons work, no reseting with pushing buttons in any sequence. Thermal fuse has continuity. Getting strange readings when checking volts at all contacts. Touch one lead with one probe and I get low voltage, then touch another lead with the other probe and voltage disappears. Can you explain problem?
by Manage My Life
February 1st, 2013
Comment
0 votes
Fred M
the 2nd image below show the cycle chart for the test. It shows what part is turned on and for how long. Could you tell if the circulation motor ran after it filled?
by Fred M Earned 3,503 community points in Appliances
December 15th, 2012
Comment
0 votes
Manage My Life
I tried running this test and it will not make it thru the whole test it just shuttsoff at all different times durring the cycle when it shuttsoff there are no lights on the panel could it be the control board
by Manage My Life
December 14th, 2012
Comment
0 votes
Fred M
The instructions to enter and run the diagnostic test are in the images below. The 1st image tells how to start the test and the 2nd image shows what should happen during the test. I hope this helps. You can reply with any additional details or questions for further assistance.
by Fred M Earned 3,503 community points in Appliances
December 12th, 2012
Answered in 3 hours
Comment
0 votes
Manage My Life
When ever there are error codes and self test available for Whirlpool dishwasher, it makes for an easy diagnose. I hope the links provided below are helpful while an expert responds to your specific model instructions.
by Manage My Life
December 12th, 2012
Answered in 6 minutes
Comment
0 votes
Didn't find what you are looking for? Ask a question