Parts Within Temperature Control System of Kenmore Stove Model # 911.92714021
Can you tell me the parts involved in the thermostat and display system for the stove above as well as any other part involved? Basically, the display temperature on the stove top display is not matching the actual temperature in the stove. The temperature chosen on the temperature knob on the stove top is not matching the temperature in the stove.
For example, if the stove knob is turned up to 400, the actual temperature is 350 inside, yet the temperature display on the stove top is reading 400.
Can you please tell me all the parts involved in the thermostat system?
Could the actual input, temperature knob be sending the wrong temperature input?
We have changed the temperature sensor (part inside the stove) and it hasn't fixed the problem.
Any help on this issue would be greatly appreciated.
Model number of Kenmore stove is 911.92714021
to answer a question
2 Answers from these members:
I can understand your need for the parts that are involved with the thermostat on your stove. While you are waiting for your expert answer, I did some research on the unit. At this time, I was unable to locate information that would be helpful in regards to your question. Some of these questions that are asked will need specific research and will be answered by an expert with-in two business days but usually sooner.
Thank you for your question. I can understand your concern about the oven temperature. There are only 2 parts involved in controlling the oven temperature. The sensor # WB21T10007 and the control # WB27T10231. When checking the temperature, make sure you are using a good thermometer that is designed to check an oven and always place the thermometer in the center of the oven. Allow the oven to cycle 3 times when checking the temperature. If the temperature is off, the control can be adjusted (see image). If the temperature is only 50 degrees off, the control may be able to be set enough to correct this. If the temperature is off more than 50 degrees, the control may need to be replaced. I hope this will help you. If you would like more assistance, reply to this thread and I will be glad to assist you further.
Didn't find what you are looking for?
Get up to