Your question was published, help is on its way!
Toro 7-25 Model 56125. Need help with Throttle Linkage Connection
Please help. I recently bought a used Toro Model 56125 riding mower. I had discovered a gas leak coming from the carburetor area. I replaced some parts on the carburetor but did not take note of how the throttle linkage was connected. The carburetor is put together correctly but I cant get the linkage right. I read the following advise on another site but would appreciate a diagram for the linkage to show me exactly what goes where.
This has the Throttle Control Bracket Bolted On Top of the Carburetor. The Spring is Attached to the Lower Hole of the Governor Arm and to the Pivot on the Control Bracket. The Solid Link Goes from the Upper Hole in the Governor Arm to the Carburetor Throttle Valve Control Plate. The Carburetor to Governor Arm Link is Hooked Up Before the Carburetor is Bolted to the Engine. Tilt the Carburetor and Insert the Linkage Into the Throttle Control Plate, the Roll the Carburetor Upright and Bolt the Carburetor to the Engine
to answer a question
5 Answers from these members:
Managemylife.com is always a great resource to find the answers to just about anything. I know this information can be very helpful for you to have. While you have been waiting for your expert to respond, I did some research but I was unable to locate information that would be helpful with regards to your question at this time. Your expert will be answering you within two business days but usually sooner.
by Manage My Life
Answered in 15 minutes
Didn't find what you are looking for?