Smaller settings are essential for proper maintenance (spark plugs, smaller bolts, etc.) These are fairly easy to read. Clicker works fine at light settings.
Broke the first time i used it, it started free wheeling after the 4th bolt at only 28 ftlbs of tq. Then it would only work in reverse. Huge chunk of garbage they need to start making in them USA.
I been looking to upgrade from the old beam styles. So I must say I'm impressed so far I decided after reading the reviews here I better check this wrench out before I depend on it or put the lives of my loved ones in it's hands (lugnuts). I figured I'd better do some testing of my own so I did just that and then checked the torque with my beam style wrenches after much testing I have to say it's within the advertised 4% as long as you're in the middle of the torque range it's closer to within 1% accuracy it was always dead on or so close I couldn't see a difference at the lower end or higher end that's where I'd see the 4% coming into play but I didn't notice that much of a difference at any point of my testing the worst reading I seen was on the lowest setting and was off by 2 pounds