Craftsman ProSeries 1/2 Inch Compact Impact Wrench
Points you can use
- Hard Hitting Twin Hammer Mechanism
- 800 FT-LB. Maximum Torque
- Internal Silencing Technology
- One-Hand Operation with "one click" forward/reverse action
- Ergonomically designed grip
Most Helpful Reviews:
I bought this gun to replace my IR, first is way lighter than my old gun, second is so quiet and so far so good, I haven't have any issue jet, the only negative point is that leaks oil on the trigger other than that, I can't make any complaint. I strong recommend it, if you want a good product for a little bit of money this is your choice.
I have owned this gun for maybe 3 months. Have oiled it every single time ive used it. I am a diesel mechanic but I do not abuse this gun by any means. The toughest job ive made it do was take axle nuts off and some shock bolts. Which isnt anything too crazy, it did it with ease. This gun does have a lot of power, I cant complain about that. BUT if you are working around any grease or dirt AT ALL it will get stuck in the little dual trigger design and the gun will get stuck on, its annoying to have to stop working and clean that out. Also ive experienced many times that when tightening bolts the reverse switch pops out just with the hammering of the gun causing the gun to slip into reverse and now you are taking back out the nut or bolt you were trying to tighten. I will be replacing this gun with an IR, they have a much better trigger design and a better forward/reverse switch.
Those benefits were not conditioned on the positive or negative content of the review.
1/2compact pro series impact wrench
|I have used it once taking apart break hubs and axle shafts on my Silverado. This thing worked great! I Highly recommend it
impact wrench
|was a good price and compact, nice fit.
Nice impact wrench
|I like my impact wrench it's strong to take off and lite to handle. I would recommend this to anybody
The design of this gun sucks
|I have owned this gun for maybe 3 months. Have oiled it every single time ive used it. I am a diesel mechanic but I do not abuse this gun by any means. The toughest job ive made it do was take axle nuts off and some shock bolts. Which isnt anything too crazy, it did it with ease. This gun does have a lot of power, I cant complain about that. BUT if you are working around any grease or dirt AT ALL it will get stuck in the little dual trigger design and the gun will get stuck on, its annoying to have to stop working and clean that out. Also ive experienced many times that when tightening bolts the reverse switch pops out just with the hammering of the gun causing the gun to slip into reverse and now you are taking back out the nut or bolt you were trying to tighten. I will be replacing this gun with an IR, they have a much better trigger design and a better forward/reverse switch.