Craftsman Router and Router Table Combo
Points you can use
- A powerful 9.5 amp, 1.75 HP motor runs at 27,000 RPM to slice through tough wood without a problem
- Permanently lubricated router comes with sealed ball bearings for longer motor life
- 334 sq. in. laminate-surface tabletop gives you plenty of room to work
- Cutting depths can lock down in microfine adjustments
- Fence adjusts for proper bit clearance
- Infeed and outfeed extend up to 2"
- Jointing fence offsets up to 9/16"
- Above-the-table cutting height adjustment works with most Craftsman routers
- Includes a double outlet power strip with safety lock
- Adjustable miter gauge lets you go up to 60° in both directions
- 3 Insert rings have opening diameters of 1-1/4", 1-1/2", and 1-3/4"
- Dust extraction port connects to your shop vac to reduce the need for cleanup
- Comes with router, 1/4" collet, wrench, table, fence, dust guard, two feather boards, miter gauge, three insert rings, hardware and manual
Most Helpful Reviews:
Overall, I like this router and router table combo. It has the fences that I wanted in order to repeatable edge routing. It is heavy enough to be used on small pieces without permanently mounting it to a bench. The router, itself, is strong enough to cut 3/4" dados in solid maple (the specific task I used to justify buying it). It is not perfect, though. The collar around the bit sits lower than the table surface ... this tends to cause the wood that I am routing to catch a bit as I push it along the fence. Depending on the bit that you are using, this could be a significant issue. I also found that without a shop vac attached to the discharge tube, shavings tend to collect and clog the tube. I also had some issues with the shavings burning (but, to be fair, that may be more a function of the hard wood that I am using and the quality of my router bits). On the positive side, I like the extra outlet attached to the on/off switch on the table. This allowed me to clamp and use a work light on the table.
Tried using router and it would not turn on. So I started going through the instruction manual. Found out the book had been highlighted by someone. And the the bushing where bad . And this is supposed to be brand new.
Those benefits were not conditioned on the positive or negative content of the review.
Sears sending spam daily
|I never got it to purchase was discontinued keep getting this email Sears is out of business