Kenmore 1010 6 ft. Snap-Lock™ Flexible Pipe
Points you can use
- Three 90-degree turns possible with 6 in. clearance and 1 ft. of length
- Snapping Collars eliminate need for clamps between parts
- Easy to install
- Recommended for a 13’ x 13’ room
- Dimensions: 4” diameter x 6 ft. L
Most Helpful Reviews:
I bought the Kenmore 6 ft. Snap-Lock Flexible Pipe for my dryer. It is a nice one piece alternative to fabricating a lot of smaller pieces together. It says it takes 6 inches of pipe to complete a 90 degree turn, but I would argue it takes 9 inches. Note that a clamp is still needed to secure the pipe to the dryer, and to the wall, and that those clamps are not included.
Might have been more useful covering the Thanksgiving turkey. Trying to "stretch" this stuff and bend it to fit the opening without tearing it is almost impossible. Might work if it is to go in a straight line, so to speak. For me it was a complete waste of time and money.
Those benefits were not conditioned on the positive or negative content of the review.
Dryer attachment
|I was told I needed this new for the new dryer. I had the same piece from the old dryer. Don’t know why I had to have this!
It's a dryer vent pipe!
|This is a dryer flexible vent pipe. Very sturdy, strong.
meta expectation
|Ihstalled by installation crew
You can clamp or use special tape you get from plumbing supply to attach them
Need Further Assistance? Check out my page ma.syw.net?a=CatherineHelp013