Skip to content
?
Manage My Life

Kenmore Washer (48112) E23 error code

Hey all, I have a Kenmore front load washer model #48112. When I hit the start button the NO SPIN led lights up (after about 3 seconds)then it shuts down. I am getting the E23 error code. I removed the front lower panel and cleared out the drain pump (some change, hair ties, etc were in there)and replaced. Still doesn't work. I believe this happened while the washer was running and there was a power outage (2 seconds) I ran a diagnostic test and everything checked out (water started, barrel spins, etc) Should I check the voltage on the drain motor or just replace the control board like the manual says? Any advice is appreciated!

Tags
Kenmore , Washers
4 Answers from these members:
Joseph Perez
by Joseph Perez Earned 57,149 community points in Kenmore
October 31st, 2011
Answered in 2 minutes
Comment
0 votes
Manage My Life
by Manage My Life
October 31st, 2011
Answered in 12 minutes
Comment
0 votes
Manage My Life
by Manage My Life
November 1st, 2011
Answered in 17 hours
Comment
0 votes
Manage My Life
by Manage My Life
November 2nd, 2011
Comment
0 votes
Want to get updates on new answers?
this question
Answer this question
Didn't find what you are looking for? Ask a question
Get up to
60
% off
On Washers