Skip to content
Manage My Life

How do I replace digital control panel circuit board on my Jenn-Air range?

This is Jenn-Air electric range with convection oven. It is model SCE30600B. We purchased the control panel circuit board from the Sears parts dept. We've unplugged the old one & plugged the new part in. When we turn the electricity back on, the oven light & fan both run constantly. The numbers on the digital display show & flash a time of 8:34 but none of the touch pads are responding. We then put the old part back in and turned the electricity back on. We get the same thing: Oven light & fan both on steadily, etc. Quite a while ago, we were getting a fault code, I think F-1. Can you help us?

Ranges , Wall Ovens , Appliances
1 Answer from this member:
by LYLE W. Earned 100,020 community points in Appliances
February 5th, 2010
joseph stackhouse
Ok, I replaced the control board a couple years, cause you couldn't read the display..Now after the oven heats up tp maybe 350, after about 45-60 min later it quits and give a code and has an alarm beep, I looked the code up online and it said the overlay assembly membrane needed to be replaced.. Any tricks for the ribbon wires before I take it apart ?
0 votes
Want to get updates on new answers?
this question
Answer this question
Didn't find what you are looking for? Ask a question
Get up to
% off
On Ranges